Pro-Series S3VT Kit [4 Valves 6025]

Tech Data

KIT PN 6025 TECHNICAL DATA

S3VT VALVE PN 6009-DM10-S3VT

• 12 V DC, 3’’ Full flow valve
• On board Electronics Controller with feedback gate position control
• High accuracy Semiconductor position sensors
• IP 66 Compliant – waterproof, sealed electronics
• Reverse Polarity protected
• Power-On safe ‘homing’ to closed position
• Operating time: 0.5 sec Typical at 12 V; 0.75 sec max
• Sensors provide Red (Open), Green (Closed) LED status to operating switch
• 2 ports for 2 switches (2nd switch option)
• Port Interface: Waterproof IP66 connector when mated and secured to male
• Connector Type: Custom molded, 10 mm OD x 37 mm L, 4 pin female, gold plated contacts
• Screw-on protective cap (included on unused port if applicable)
• Compatible with 2 types of switches – for exposed or protected locations
• Green Power-On LED on the on board controller
• Back up Active motor safety: Internal timer 0.8-0.85 seconds
• Voltage range: 10.8 volts – 14.4 Volts. 12 V Nominal
• 12V power connector pigtail with seal included
• Stand by current under 50 ma with 2 switch LEDS active
• Slim profile, under ½”, on-board controller – fits tight spaces
• Internal gearing: 303 Stainless steel, Swiss made
• Durable ABS, injection molded Valve Body and Parts
• Manual Override from both sides of valve with 1/8” Allen key included
• Easily attached to 3″ ABS male or female bolt-on flange fittings; Mounting HW included
• Adaptable to most pipe sizes with proper fittings
• Special Seals Included
• Lubricant Dow Corning 111 included

PENTA SWITCH PN 5970-EXT

• Illumination: 4 Switches with Internal Bright RED and Bright GREEN LEDs;
1 Master Switch with Internal Bright RED LED
• Hole cutout for Penta snap fit housing: 5.11 inch x 1.90 inch (129.8 mm x 48.3 mm)

QUAD SWITCH PN 5944-INT

• Illumination: Internal Bright RED and SOFT GREEN LEDs
• Hole cutout for Quad snap fit housing: 4.08 inch x 1.90 inch (103.6 mm x 48.3 mm)

Technical Specs. common to all Operator switches in both PNs:

• Mounting: All Switches come pre-installed in snap-fit Penta and Quad housings
• Switch Type: Momentary contact rocker with custom PCB assembly
• Sealing: Switch to Housing sealed with closed cell gasket; Switch sealed with dual seals around LEDs and rocker stem
• IP rating: IP66 from front panel
• Hole cutout for snap fit housing: 4.08 inch x 1.90 inch (103.6 mm x 48.3 mm)
• Panel thickness : Min: 0.062 inch (1.57 mm) Max: 0.375 inch (9.52 mm)
• Rear clearance requirement: 1.92 Inch measured from front of panel (Housing seating surface)
• Interface: 6/4 RJ 11 socket, gold plated contacts, mounted on rear PCB assembly
• Actuator: Aesthetic symmetrically curved, black nylon
• Actuating force: 460 grams +/- 30, (4.5 N +/- 0.3)
• Actuating distance to rocker center: 20 mm
• Lens – Dual prismatic, clear polycarbonate set in rocker
• Operating life: 50,000 cycles min
• Industry certification: Switch meets MIL Std. 202F, MIL Std. 810C, UL 1500, ISO 8846, IEC 60529 and BS 5490

MASTER SWITCH PN 5890 TECHNICAL DATA (Pre-installed in Penta housing)

• Sealing: Switch to Housing sealed with closed cell gasket; Switch sealed with seal around LED and rocker stem
• Rating: 4-14 V DC, 20 Amp
• IP rating: IP66 from front panel
• Panel thickness range: 0.062 (1.57 mm) to 0.375 inch (9.52 mm) (Refer Doc DM 114 for details)
• Rear clearance requirement: ≥1.92 Inch (48.8 mm) measured from front of panel (Housing seating surface)
• Connections: 12 V In, 12 V Out (switched), and Ground for power On-LED.
• Terminals: 1/4”(6.3mm) Quick Connect, Industry standard
• Actuator: Aesthetic symmetrically curved, black nylon
• Actuator Travel: 18 Degrees
• Lens – Single prismatic, clear polycarbonate set in rocker
• Operating life: 50,000 cycles min
• Certification: MIL Std. 202F, MIL Std. 810C, UL 1500, ISO 8846, IEC 60529 and BS 5490

IP66-2 CABLE DM PN 5955-IP66-2 20’ Rnd. Cable Ass. TECHNICAL DATA

• Type: AWM Style 2464 Cable
• Core: 4
• Wire: 4 x insulated cores, stranded copper, 7/30 per core, 26 AWG, Black Outer Sheath
• Cable OD: 3.5 mm (0.140 inch)
• Length: 20 Ft std.; (Custom lengths available)
• Temp Rating: 60 Deg. C
• Voltage rating: 150V
• Controller interface: Waterproof IP66 connector when mated and secured to female
• Connector Type: Custom molded, 12.9 mm OD x 36.5 mm L., 4 pin male, gold plated contacts
• Switch interface: 6/4 RJ11 Plug, Gold plated contacts, for stranded copper round wire